Our dishwasher is one of the important appliances we have inside our home. However, once it malfunctions, we end up not finishing our chores. Are you considering hiring a professional dishwasher repair NYC company for your problem?
Following are some of the common problems and solutions you can do before calling a professional. Feel free to refer to your owner’s manual for specifics about your certain appliance.
Problem #1. The dishes remain dirty or have sports after washing them
Potential causes:
- Water temperature – If the water temperature isn’t high enough, the drying time is less. Thus, it increases the chance of spots. Make sure you check the manual for the suggested temperature. If it’s hotter than you would want your sink to be, then consider getting another appliance
- Hard water – A rinse agent could help avoid a film from forming on items, especially in hard water areas. Consider a water softening system if your water is extremely hard.
- Detergent choice – Various detergents will offer various results. You may like to try another form or brand.
- Spray arm problems – A small item or fallen utensil can easily block the spray arm from working. If it does not move, it won’t efficiently spray the water throughout the appliance. Another concern is debris blocking the small holes in the arm. Eliminate the wire baskets and unscrew the spray arm. Eradicate any excess foods and place the arm back in place.
- Overloading – The water and detergent can’t properly clean when you place too many dishes on top of one another. You should check the owner’s manual first for loading instructions and suggested capacity.
Problem #2. A large pool of water or slow leak on the floor during or after operating
Here are the potential causes and solutions for this dishwasher repair NYC.
- Detergent – Using the wrong detergent will not just clean your dishes properly. If you don’t use a product specifically intended for dishwashers, you can problem problems with too many suds or foams that can spill out of the appliance.
- Float switch – The float and float switch also keeps the appliance from overfilling with water. Remember that the switch is often located in the tub’s lower front. Check the manual if you have difficulty locating it. What’s more, a dirty float switch could become stuck, so the tub gets full, causing a leak. Always clean the float switch with a sponge or toothbrush and check that it moves freely up and down.
- Bad seal – Are you noticing drips directly under the door? Then you could have a bad seal or gasket. The seal is often made of vinyl or soft rubber, which becomes dirty and less flexible over time. First, check for obvious damage and change if needed. If you do not notice any visible problems, clean that with an all-purpose cleaner or sponge.
Keep in mind that doing routine maintenance lowers the need for dishwasher repair NYC in general. Clean the seal regularly, remove debris and waste from the tub and always use the correct detergent.
